How to inject steroids yourself

How to operate steroid injection
When you talk about this, you will find that most people's views on steroid injection are ridiculous. Steroids can't be injected intravenously. Steroids are mainly injected intramuscularly or subcutaneously.
preparation
The first thing you need to know is how to prepare for steroid injections. It's not just about putting the needle in the meat. Here are eight steps we need to follow to inject anabolic steroids. If these steps are not followed, there is a high risk of infection or unnecessary muscle soreness.
Step 1: choice of needles - there are many kinds of needles according to the injection dose. You need to choose the right one. Of course, you don't need to choose a large needle, but can't be too small or you won't get in. In most cases, 2.5ml and 5ml needles are common choices. At the same time, pay attention to the use of disposable needles and keep them clean, and cover the needle tube after taking medicine.
Step 2: draw in air - before you draw steroids into the syringe, you need to draw in a small amount of air, which is the same as the amount of steroids you will draw in. This step is not necessary, but it can make step 4 easier.
Step 3: insert the needle into the bottle containing steroids and blow in all the air. This will make it easier to extract steroids next.
Step 4: extract steroid drugs - gently pull the piston of the syringe to make all the drugs in the bottle enter the syringe. Some people will find it helpful to extract a little more. In this case, you need 5ml of "withdraw needle" to make the withdrawal faster and easier. If you do so, replace the withdrawal needle with a 2.5ml needle.
Step 5: remove air bubbles - now steroids are in the syringe, push the syringe piston and tap the tube with your fingers to remove all air bubbles. This will lose a little bit of medicine, which is why we took out a little more before.
Step 6: Disinfection: select the site of intramuscular injection to disinfect with alcohol. Alcohol cotton ball can be used, but medical sponge is a better choice.
Step 7: insert the needle & draw back ---- after disinfection, insert the needle into the sterilized part but do not start the injection first. When the needle is inserted, gently pull the piston of the syringe, and this step is called pumping back. If there is blood coming in during the withdrawal, pull out the needle and change another place for injection. This means that you hit the blood vessels, which may cause the so-called "Trebolone cough". The reason for this is that trebolone often causes this reaction, but sometimes testosterone does. A part of steroid will enter your lungs and cause a very painful and violent cough, which will return to normal after about 5 minutes.
Step 8: inject steroids - if you strictly follow the first seven steps, and there is no blood entering the syringe during suction, you can inject steroids. Push the piston until all the drugs enter the injection site.
After injection
Now you know how to inject, but what you need to know is how to do it after injection. This step should not be ignored.
There are three steps to take
Step 1: do not pull out the needle immediately after the injection. Hold for 20-30 seconds to make sure all the drugs are in the body. If you skip this step, it's likely that there will be no fully entered drugs flowing out or injected into the skin, which is very painful.
Step 2: pull out the needle and use a new clean cotton ball to press the needle hole. Hold it gently for 20-30 seconds. It may give a little blood, but it doesn't matter.
Step 3: take off the cotton ball and massage the injection site to ensure that all steroid drugs are completely injected.
Selection of specific injection site
In general, steroid injection is usually performed on the hip, thigh and shoulder.